5. Preventing accidental arming:
If you want to prevent anyone from accidentally arming the system, your installer can program the
alarm system to require your disarm code to also serve as an arming code. When programmed to this
option, you must enter your code before you press the * or A key (AWAY mode) or # or H key
(HOME mode) to arm the system.
DISARMING
How to TURN OFF the alarm system
Enter your disarm code.
When the system is disarmed, you will hear “CONTROL IS DISARMED” over the phone or through
the speaker and the red HOME LED and/or green AWAY LED will go out.
When you open an entry door while the system is armed to AWAY, you may hear a “PRE-ALARM”
spoken instead of hearing the tone. The PRE-ALARM is “ENTRY DETECTED” followed by a brief
description of the zone that has been violated. For example: After opening the front door while the
system is armed to the AWAY mode the system will speak, “ENTRY DETECTED FRONT DOOR”.
This will continue until you enter your disarm code or entry delay expires. You have 20 seconds to
disarm the system before the BURGLAR alarm activates. Your installer can increase or decrease this
time at your request.
If an alarm activation has occurred while you were away, each pre alarm “Entry Detected”
annunciation will be preceded by a “SYSTEM SHOWING ALERT” announcement. In addition, the
yellow STATUS LED will be flashing. Pressing the status key on the keypad will cause the system to
announce which zone(s) are showing ALERT.
In the unlikely event of a “FALSE” or “ACCIDENTAL” ALARM, enter your code to disarm the
system and stop the audible alarms. Check with your installer and/or central station to determine the
proper procedure for dealing with false or accidental alarms. Depending on the structure of your
central station, you may need to notify the central station or they may call you. In either event, be
prepared to recite your central station account number or abort code to verify your identity.
CLEARING ALERT STATUS FROM KEYPAD DISPLAY
After the system has been disarmed following an alarm activation, the STATUS LED will be flashing
and the system status will display (or speak if requested) the violated zone’s description followed by
“ALERT”. This is useful for determining which zone(s) were activated after the alarm has been
silenced. To clear the ALERT status, simply re-arm the panel and disarm.
BYPASS
To BYPASS a zone is to temporarily remove that zone from the system. To enter BYPASS mode,
your system must be disarmed. Make sure the system is disarmed and follow the steps below:
1. Enter your disarm code and immediately press the 9 key to gain entry into BYPASS mode. You
will hear “BYPASS MODE, ENTER ZONE NUMBER.”
6
(77 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales