Destiny 4100 Especificaciones descargar pdf (Pagina 7)

Specifications

Electrical: Voltage Input: 16.5 VAC 40 VA from supplied transformer

External Speaker: 10 Watt minimum, 8W horn type - Ademco 713 or equivalent. Total

speaker load must be between 4W and 16W.

Internal Speaker: Speaker supplied in all compatible keypads. For stand-alone

operation 10 Watt minimum, 8W - Ademco 746 or equivalent. Total speaker load must

be between 4W and 16W. For UL installations, an Ademco 705 speaker must be

connected to the "EXT" and "COM" terminals.

Auxiliary Power Output: 13.5VDC, 1.85 AMP max - Not to be used in a UL installation

Switched Fire Output: 13.5VDC, 1.85 AMP max

Two Wire Smoke Detectors: Up to 12 per system

Note: Switched Fire Output and Two Wire Smoke Detectors are not to exceed

10 mA in a UL installation

Back-up Battery: 12VDC, 7AH gel cell. YUASA NP7-12 or equivalent.

For UL installations use 2 - batteries with SA5140-1 cable assembly.

CAUTION: Total current draw of Auxiliary + 4 wire bus power is not to exceed 2 Amps.

In UL installations total current draw must not exceed 400mA. Test installation for 1

minute in alarm to ensure sufficient power.

Dimensions: 15.1" L x 13.05" W x 3.5" D w/ door.

Nonvolatile Memory: Maintains programming options with no power to the control.

Communicator: Supports: 3/1, 4/1/1, 4/2, 4/2 extended, Ademco Contact ID

47 report codes

DTMF and pulse dialing

DPDT line seizure

Two telephone numbers and two account codes, dial both numbers

Split reporting of selected codes

Alternate number dialing if primary number fails

Programmable number of dialing attempts

Programmable to enable or disable the communicator

Two-Way Voice: Microphone inputs: 3 separate, individually controlled channels.

Microphone: 5V shielded 2 conductor omnidirectional electret condenser microphone.

Frequency response 50-10K. -64db sensitivity, TWM-25K or equivalent.

System Zones: 16 - programmable fully supervised wireless alarm points

8 - programmable fully supervised hardwire inputs on the control panel

1 - 2-wire smoke loop

1 - keypad alert

1 - local phone activation

1 - remote phone / phone line monitor activation

1 - AC loss / control low battery / communicator

Auxiliary Outputs: 1 - Form C 10A 24V system relay

4 - Pull to ground, 12 volt, 100mA outputs, not to exceed 500mA total.

Not to be used in a UL installation

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Sin comentarios

Destiny 4100 Especificaciones Pagina 7