Destiny apex 6100 Manual de usuario descargar pdf (Pagina 58)

Sequence of Operation

System Sequence of Events

Objective Equipment List

Apex Technical Support 800-272-7937

Option 1

Page 4-19

- Application Note -

End User Convenience

Use independent arm and

disarm switches so that

each switch will perform

only the arm function or

only the disarm function.

¨ Apex Destiny 6100 control panel,

rev. 8.05 or greater

¨ System Sensor RR1 Relay

- Independent Arm / Disarm Switches -

Typically used when an outside switch is needed for arming only

with a disarm switch located inside.

Activating the designated arm switch will only arm the control to Away. Activating the

designated disarm switch will only disarm the control. This application can be used to

restrict certain users to arm only and others to disarm only.

Example: A card / proximity reader can be used to activate the arm/disarm switches.

1) Closing the arm switch will trip Zone 1 (Arm/ Disarm) causing the panel to arm to Away.

2) Arming to Away will activate Control Channel 1 (Arm Only) causing Relay 1 to energize and

block the common signal from the arm switch until the panel is disarmed.

3) Arming to Away also will activate Control Channel 2 (Disarm Delay) causing the on-board relay

to energize and block the common signal from the disarm switch until the automatic turn-off time

has expired.

Note: The automatic turn-off time must be greater than the exit time

to prevent the system from arming to home instead of disarming.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 76 77

Sin comentarios

Destiny apex 6100 Manual de usuario Pagina 58